Learning Operating Code Of Another Remote Control - Toshiba DW65X91 Owner's Manual

USING THE REMOTE
LEARNING OPERATING CODE OF
ANOTHER REMOTE CONTROL
This remote control is capable of learning operating codes from most infared
remote control transmitters. You can control the functions of your TV and a
variety of video/audio equipment with the supplied remote control only.
The A to H buttons can be used as the Learning buttons.
1. Set the USE/LEARN switch to the "LEARN" position.
2. Place the supplied remote control and the remote control transmitter to
be learned, head to head approximately 1 to 3 inches (3 to 8 cm) apart.
Supplied Remote
Control
3. Hold down the button to learn (A to H) on the supplied remote control
for about 1 second until the LEARN indicator lights up.
When you press a button other than a Learning button, the indicator
will blink.
4. Hold down the button of the function to be learned on the other remote
control transmitter for about 3 seconds until the LEARN indicator goes
off.
Note:
If the LEARN indicator blinks, the supplied Remote Control cannot learn the
operating code or an error has occurred.
5. Repeat steps 4 and 5 for storing other functions into other buttons.
6. Set the USE/LEARN switch to the "USE" position.
7. To check your programming, operate the appropriate equipment with
the supplied remote control. If the equipment does not operate as
expected, repeat steps 1 to 7.
If needed, try changing the distance between the two remote controls.
28
USE LEARN
Head to Head
1-3 inches apart
Remote Control to be
learned
USE LEARN
LEARN/
TV/VIDEO TV/SAT POWER
TV
DVD
VCR
REW RLAY FWD
CABLE
SWAP SOURCE POP
TV/VCR PAUSE STOP SLOW
ANTENNA STILL
O K
( )
ENTER
MENU
REC RETURN EXIT
MUTE
CH VOL
PIC SIZE
A B 1 2 3
4 5 6
C D
7 8 9
E F
0
OK
G H
+100 / ENTER
USE LEARN
LEARN
indicator
EXIT
MUTE
Learning
buttons
USE/
LEARN
switch