USING THE REMOTE
8. Attach the supplied Template to the remote control to enter the function
names of the learning buttons (A to H) you have programmed. Use a
ballpoint pen, etc. to write the function names.
1
A
B
4
C
D
7
E
F
OK
G
H
+100 / ENTER
USE
LEARN
Cancelling the learned operating codes
1. Set the USE/LEARN switch to the "LEARN" position.
2. Hold down the button of the function to cancel on the remote control
for about 1 second until the LEARN indicator lights up.
3. Hold down EXIT and MUTE at the same time for about 6 seconds
until the LEARN indicator goes off after blinking.
Note:
You cannot cancel the programming if you release the button while the indicator
is blinking.
4. Set the USE/LEARN switch to the "USE" position.
2
3
5
6
8
9
0
USE
LEARN
USE
LEARN
29