Table of Contents
Advertisement
_
INTRODUCTION
Programming the Remote
Control
!,
f
--CABLIE
_
W_
TIMER
@®
:::g
STOP _
PLAY PIP
C]ED
g g
STILL
LOCATE
SWAP
"I'08HIBA
For future reference, write the code
number you set.
VCR CODE:
CABLE COl)E:--
:
Note:
You have to reprogram the Remote
Control when you change its batteries.
• This Remote Control is programmed
to operate TOSHIBA VCRs.
• To operate VCRs (or Cable converters) other than TOSHIBA models,
perform the following procedures before operating.
Referto the *VCRcode
table=(or
"Cable TVconvertercode
table')
on pages 16 and 17 to find the code number that corresponds to the
brand name of your VCR (or your converter).
If more than one number is listed, try each one separately until you
find the one that works.
Set the TV/CABLE/VCR
switch to "VCR" (or "CABLE").
3
4
5
While holding down RECALL, press the Number
buttons to enter
the three digit code number for your brand of VCR (or converter).
Point the Remote Control at the VCR (or at the converter) and press
POWER to test the code number.
_lf
the number is correct, the VCR should turn on.
_lf
the VCR does not respond to the Remote Control, repeat steps
1 through 4 with another code number.
Reset the TVICABLE/VCR
switch to "'IV" to control the TV.
Notes:
• Some newer VCRs are capable of working on either of two remote '
codes. These VCRs have a switch labeled "VCR 1/VCR 2."
If your VCR has this kind of switch, and does not respond to any of
the code numbers for your VCR brand name, set the switch to the
other position ("VCR 1" or "VCR 2") and reprogram the Remoti_
Control.
• In some rare cases, you may not be able to operate your non-
TOSHIBA equipment with the supplied Remote Control. This is
because your equipment may use a code that is not provided with
this Remote Control. In this case, please use the equipment's own
remote control.
Advertisement
Table of Contents
