Kenmore 7749 - Elite 30 in. Gas Range Installation Instructions Manual

30" gas range
Hide thumbs Also See for 7749 - Elite 30 in. Gas Range:

Advertisement

INSTALLATION
AND SERVICE
MUST BE PERFORMED
BY A QUALIFIED
INSTALLER.
IMPORTANT:
SAVE FOR LOCAL
ELECTRICAL
INSPECTOR'S
USE.
READ AND SAVE THESE
INSTRUCTIONS
FOR FUTURE
REFERENCE.
If the information
in this manual is not followed
exactly,
a fire
or explosion
may result
causing
property
damage,
personal
injury or death.
FOR YOUR SAFETY:
m
Do not store or use gasoline or other flammable
vapors
and liquids in the vicinity of this or any other appliance.
WHAT TO DO IF YOU SMELL
GAS:
• Do not try to light any appliance.
• Do not touch any electrical
switch; do not use any phone
in your building.
• Immediately
call your gas supplier
from
a neighbor's
phone.
Follow the gas supplier's
instructions.
• If you cannot
reach your
gas supplier,
call the fire
department.
Installation
and service must be performed
by a qualified
installer,
service
agency or the gas supplier.
Refer to your serial plate for
applicable agency certification
• ALL RANGES
CAN TIP
• INJURYTO
PERSONS
COULD
RESULT
• INSTALL
ANTI-TIP
DEVICE
PACKED
WITH
RANGE
• SEE INSTALLATION
INSTRUCTIONS
Note. For appfiances
installed
in the
State of Massachusetts
see page 2.
OVERALL
DIMENSIONS
253/4"
_--
29-7/8"
--_
--
FRONT
SIDE
VIEW
VIEW
47-3/4"
Maximum
36 +1/8"
\
44 5/8"
"_
Door Open
\_
29 7/8 '''''''_>
\ __
\ _,""'_"
_ - _ -
Clearances
and Dimensions
1.
Location--Check
location where
the rancje will be installed. Check
for
proper
electrical
and gas
supply, and the stability of the
floor.
2.
Dimensions that are shown must
be used.
Given
dimensions
provide
minimum
clearance.
Contact
surface must be solid
and level.
pin 316259334 EN SP FR (0408)
*Minimum
to --
Side Wall
on Either
"5 "-1_
Side of
Range 5"
36"
1
30 _
Minimum
_
Minimum to
1-13"_1
,, Cabinets on
Maximum Depth
_
_lr--_
Either Side
for Cabinets
of Range.
Above Range Top.
®®
®
®®
14_-
30"
_
0" Clearance
Below
Cooking
Top and at Rear
of Range,
Provide
Proper Fuel Type
Before Proceeding: Your range is preset to operate on natural gas only. This
model was shipped convertible
from the factory with the necessary
parts and
conversion instructions supplied.
DO NOT attempt to convert this range to L P/Propane settings without
the proper LP/Propane conversion kit provided with the range or obtained from your
dealer.
Follow all instructions provided with this conversion kit.
English p 1-8
EspaSol p 9-16
Fran£ais
p 17-24

Advertisement

Table of Contents
loading

Summary of Contents for Kenmore 7749 - Elite 30 in. Gas Range

  • Page 1 INSTALLATION AND SERVICE MUST BE PERFORMED BY A QUALIFIED INSTALLER. IMPORTANT: SAVE FOR LOCAL ELECTRICAL INSPECTOR'S USE. READ AND SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE. If the information in this manual is not followed exactly, a fire or explosion may result causing property damage,...
  • Page 2: Important Safety Instructions

    Important Notes to the Installer Never leave children alone or unattended Read all instructions contained in these installation in the area where an appliance is in use. As children grow, instructions before installing range. teach them the proper, safe use of all appliances. Never leave Remove all packing material from the oven compartments the oven door open when the range is unattended.
  • Page 3: Before Starting

    Locate the Bracket Using the Template- (Bracket may Before Starting be located on either the left or right side of the range. Use Tools You Will Need the information below to locate the bracket if template is For leveling legs and Anti-Tip Bracket: not available).
  • Page 4 Level and Position Range- Level range by adjusting the (4) leveling legs with a wrench. Note: A minimum clearance of 1/8" is required between the bottom of the range and the leveling leg to allow room for the bracket. Use a spirit level to checkyour adjustments.
  • Page 5: Please Read Carefully

    5. Read electrical connection details below Manual Flare Flexible Flare Union Pressure and connect electricity to range. Shutoff Union Appliance Adaptor Regulator Valve Conduit Before servicing, disconnect electrical supply at circuit breaker, fuse or power cord. Electric Requirements: An individual, properly grounded and polarized branch circuit protected by a 15 amp.
  • Page 6 6. Assembly of Burner Heads & Burner Caps (for Deep Well Cooktop models only) Your range is shipped with the Burner Heads and Burner Caps in the correct locations. Packing material is located between the Burner Heads and Burner Skirts. i!! i i!iiiiiii;i!i;iill ¸i!ii:iiiiiiiiiii:ii!:iiiii i iiiii!i iiii! ¸iilil iiiiii ii iii ii i ii...
  • Page 7 Burner Flame Size ---_1 5/8" i_t__ Main Adjust flame until you can quickly turn knob from LITE to LOWEST POSITION without extinguishing the flame. Flame should be as small as possible without going out. Note: Air mixture adjustment is not required on surface burners.
  • Page 8: Model And Serial Number Location

    Model and Serial Number Location For sealed bumer ovens, the identification plate is located on the right-hand surface of the oven front frame at the storage or warmer drawer; or the lower panel area. Waist-High Burner When ordering parts for or making inquires about your range, (Self Clean Models) always be sure to include the model and serial numbers and a lot number or letter from the identification...

Table of Contents