Setting Convection Convert; Setting Add 1 Minute Feature - Kenmore 7755 - Elite 30 in. Dual Fuel Range Use And Care Manual

Setting Oven Controls
• Setting Convection Convert Feature
• Setting Add 1 Minute Feature
To set the Convection Convert feature
The _ CONV CONVERT pad is used to automatically convert a standard Baking recipe for convection baking. When
set properly, this feature is designed to display the oven set converted (reduced) temperature in the display.
Convection Convert MUST be used with a Convection Bake keypad. Cook Time or Delay Start functions may be added.
INSTRUCTIONS
Using Convection Convert feature to adjust oven
temperature from a Bake recipe (example below
when setting oven for 350°F):
1. Arrange interioroven racks and place food in oven.
2. Press _"), (See Fig. 1). If a Cook Time or a Delay Start
is desired, enter the times now.
3. Press C_oC_rt . "CONV BAKE" and the oven set temperature
adjustment will appear in the display (for this example it is
325°F). A beep will sound once the adjusted oven set
temperature is reached. (See Fig. 2).
Notes: When used with a Cook Time or a Delay Start setting,
the Convection Convert feature will display a "CF" for check food
when the bake time is 75% complete (See Fig. 3). At this time the
oven control will sound 3 long beeps at regular intervals until baking
has finished. When the bake time has completely finished the
control will display "End" and will sound 3 long beeps every 30
(_ pad is pressed (See Fig. 4). seconds until the
PRESS DISPLAY
®
Fig. 1
Fig. 2
Fig. 3
Fig. 4
The oven icon will show a rotating fan within the square. This
rotating fan icon indicates when the Convection Fan is operating
(See Figs 2 or 3)
Press (_ to cancel Convection feature at any time,
Note: The minimum amount of cook time using the Convection
Convert feature with a Cook Time or a Delay Start function is
20 minutes.
®
To Set Add 1 Minute Feature
The @ keypad is used to set additional minutes to the Timer. Each time the @ pad is pressed, another minute is
added. If the Timer is not active and the @ key pad is pressed, the Timer feature will become active and will begin
counting down from I minute. When the Timer reaches the end of the set time, "End" will display and signal 3 long beeps
at regular intervals until _ej_r is pressed again.
28