Electrolux E48DF76EPS - 48" Pro-Style Dual-Fuel Range Installation Instructions Manual page 32

STEP 8 Perform Pressure Tests
8-1 Connect the U-tube manometer to the LPG
supply line.
8-2 With electrical power to the range disconnected,
open the LPG supply valve.
8-3 Verify that the pressure is above 11 inches water
column (WC) and below ½ PSI. Consult the
factory if the pressure is not within the above
limits.
8-4 Close the LPG supply valve. Connect the range
to the LPG supply line.
STEP 9 Adjust Air Shutter Gaps
9-1 Determine the appropriate air shutter part
number for the left rear burner from Table 9-1
on page 9. Be sure to match the model number
and burner location. The shutter part number
appears on its side.
9-2 Thread the air shutter onto the left rear shutter
connector about 6 turns (see Figure 9-1).
9-3 Reinstall the burner base (see Figure 9-1).
9-4 Measure the gap between the end of the shutter
connector and the opposite end of the shutter
opening with the pocket rule (see Figure 9-2).
9-5 Compare the measured gap to the gap listed in
Table 9-2 for the appropriate model number and
the burner location.
8-5 Make sure all knobs on the front of the range
8-6 Connect the U-tube manometer to the left rear
8-7 Open the LPG supply valve. Turn on the left rear
8-8 Turn off the burner and the gas supply valve.
Place end of tube over main orifice
Figure 8-1 Pressure Test Set-up
9-6 Hold the shutter connector with the 8"
9-7 Secure the shutter with thread-locker.
9-8 Repeat steps 9-1 through 9-7 for the remaining
9-9 Check to make sure that the compression nut is
Page 8
are in the off position.
burner's main orifice with 3/8" surgical tubing.
burner. The manometer should read 10 inches
WC +/- ½ inch. Contact the factory if the
pressure does not meet specifications.
adjustable wrench. Adjust the air shutter using
the 6" adjustable wrench until the gap is to
within 1/16" (1.6 mm) of the gap indicated in
the table.
burners.
tightened into the back of each shutter
connector.