Electrolux E48DF76EPS - 48" Pro-Style Dual-Fuel Range Installation Instructions Manual page 31

STEP 7 Replace Main Orifices
7-1 Remove the two screws that hold the left rear
burner base to the stove chassis.
7-2 Hold the shutter connector with the 8"
adjustable wrench. Remove the air shutter using
the 6" adjustable wrench.
7-3 Hold the shutter connector with the 8"
adjustable wrench. Remove the main orifice
from the shutter connector using the 10 mm
open-end wrench.
Compression Nut
Main Orifice
Shutter Connector
Burner E30DF74EPS
Location (30-Inch)
Left Rear 84
Left Front 111
Right Rear 111
Right Front 118
Center Rear -
Center Front -
Table 7-1 Main Orifice Sizes (X 100 mm)
Air Shutter (remove)
Figure 7-1 Main Orifice Conversion
Professional Series Range LPG Conversion Kit
7-4 Replace the main orifice with the appropriate
size from Table 7-1. Match both the model
number and the burner location. The main
orifice size is stamped on its side. The shutter
and the burner base will be re-assembled after
pressure testing.
7-5 Check to make sure that the compression nut is
tightened into the back of the shutter connector.
7-6 Repeat steps 7-1 through 7-5 for the remaining
burners.
E36DF76EPS E48DF76EPS
(36-Inch)
112
86
86
112
118
118
Burner Base
Page 7
(48-Inch)
112
86
86
112
118
118