Status Read Command - Sanyo PDG-DWL100 - WXGA DLP Projector Command Manual

PDG-DWL100 Basic Serial Command Specifications
7.4

Status Read Command

COMMAND "CR0" [CR]
Detail Get the projector status
Acceptable
Response
Unacceptable
0 Details for Response0
0û "00" [CR]
Status: Power ON
Normal image is on screen.
0û "80" [CR]
Status: Standby
When the status is Standby, Status Read Commands are always accepted, but Functional
Execution Commands are not accepted except POWER ON Command.
"20" [CR]
0û
Status: Cooling Down in process
Execution of POWER OFF Command ("C01" [CR]) in power on status brings into Cooling
Down status.
This status automatically moves to Standby when the lamp is turned off and the fan spin
finishes after about 90 seconds (the time of spinning fan depends on models).
During this time, Functional Execution Commands are not accepted.
0û "10" [CR]
Status: Power Failure
When the power supply voltage inside the projector reaches abnormal level, the status
automatically moves to Power OFF.
The projector returns "10" [CR], which indicates the status moves to Power OFF due to
power failure. Fan also stops.
This status continues for the same period (90 seconds approx.) of the Cooling Down
operation when Power OFF executed, and then moved to Standby.
"28" [CR]
0û
Status: Cooling Down due to Abnormal Temperature in process
When the internal temperature rises abnormally, it automatically starts Cooling Down
process. Response value for this status is "28" [CR].
"%1" [CR]
"00" = Power ON
"80" = Standby
"20" = Cooling Down in process
%1
"10" = Power Failure
"28" = Cooling Down due to Abnormal Temperature in process
"21" = Cooling Down in process after Off due to lamp failure
"?" [CR]
17 / 19