Freeze On Command; Freeze Off Command; Auto Adj. Command; Keystone + Command - Sanyo PDG-DWL100 - WXGA DLP Projector Command Manual

PDG-DWL100 Basic Serial Command Specifications
6.38

FREEZE ON Command

COMMAND "C43" [CR]
Freeze the projecting image.
The behavior is the same as "FREEZE" button of the remote control except the
Detail
command only freezes the image and does not cancel it.
The projector shows the OSD "Freeze" at receiving the command.
Acceptable
Response
Unacceptable
6.39

FREEZE OFF Command

COMMAND "C44" [CR]
Cancel Freeze function
The behavior is the same as "FREEZE" button of the remote control except the
Detail
command only cancels the freeze and does not freezes the image.
The projector shows the OSD "Freeze" at receiving command.
Acceptable
Response
Unacceptable
6.40

AUTO ADJ. Command

COMMAND "C89" [CR]
AUTO ADJ. Command
Detail The behavior is the same as the key "AUTO PC" button of the remote control.
The projector does not show any OSD at receiving the command.
Acceptable
Response
Unacceptable
6.41

KEYSTONE + Command

COMMAND "C8E" [CR]
Correct keystone distortion by resizing upper part of image.
The behavior is the same as the "Keystone +" button of the remote control
Detail
A scale OSD is shown by adjusting Keystone and the scale reflects adjusting
value
Acceptable
Response
Unacceptable
6.42 KEYSTONE – Command
COMMAND "C8F" [CR]
Correct keystone distortion by resizing lower part of image.
The behavior is the same as the "Keystone -" button of the remote control
Detail
A scale OSD is shown by adjusting Keystone and the scale reflects adjusting
value
Acceptable
Response
Unacceptable
[ACK] [CR]
"?" [CR]
[ACK] [CR]
"?" [CR]
[ACK] [CR]
"?" [CR]
[ACK] [CR]
"?" [CR]
[ACK] [CR]
"?" [CR]
15/19