Power On Command; Power Off Command (Immediate Power Off); Hdmi Command; Computer 1 Command - Sanyo PDG-DWL100 - WXGA DLP Projector Command Manual

PDG-DWL100 Basic Serial Command Specifications
6.5

POWER ON Command

COMMAND "C00" [CR]
Set Power On.
(Same as the "Power On" key on the projector body / remote controller.)
Detail
No operation is started when the projector has been turned on already.
"Count Down" is terminated by receiving this command.
Acceptable
Response
Unacceptable
6.6

POWER OFF Command (Immediate POWER OFF)

COMMAND "C01" [CR]
Turn off the projector and set into standby.
Although "Power OFF" display appears when Power is turned off with ON-OFF
Detail
button of the projector and remote control, this command executes Power OFF
immediately without displaying OSD.
Acceptable
Response
Unacceptable
6.7

HDMI Command

COMMAND "C04" [CR]
Select "HDMI".
Detail
The projector shows the OSD "HDMI" at receiving the command.
Acceptable
Response
Unacceptable
6.8

Computer 1 Command

COMMAND "C05" [CR]
Select "Computer1".
Detail
The projector shows the OSD "Computer1" at receiving the command.
Acceptable
Response
Unacceptable
6.9

Computer 2 Command

COMMAND "C06" [CR]
Select "Computer2".
Detail
The projector shows the OSD "Computer2" at receiving the command.
Acceptable
Response
Unacceptable

6.10 Volume + Command

COMMAND "C09" [CR]
This command turns up the Volume.
This command works the same as "VOLUME ÿ " button of the projector and
Detail
remote control. The projector shows the OSD "Volume" at receiving the
command.
Acceptable
Response
Unacceptable
[ACK] [CR]
"?" [CR]
[ACK] [CR]
"?" [CR]
[ACK] [CR]
"?" [CR]
[ACK] [CR]
"?" [CR]
[ACK] [CR]
"?" [CR]
[ACK] [CR]
"?" [CR]
9/19