Ypbpr 1 Command; Pointer Right Command; Pointer Left Command; Pointer Up Command - Sanyo PDG-DWL100 - WXGA DLP Projector Command Manual

PDG-DWL100 Basic Serial Command Specifications
6.32

YPbPr 1 Command

COMMAND "C35" [CR]
Select "YPbPr 1"
Detail
The projector shows the OSD "YPbPr 1" at receiving the command.
Acceptable
Response
Unacceptable
6.33

POINTER RIGHT Command

COMMAND "C3A" [CR]
Move Pointer of OSD Menu to right.
Detail
The behavior is the same as "►" button of the projector and the remote control.
Acceptable
Response
Unacceptable
6.34

POINTER LEFT Command

COMMAND "C3B" [CR]
Move Pointer of OSD Menu to left.
Detail
The behavior is the same as "◄" button of the projector and the remote control.
Acceptable
Response
Unacceptable
6.35

POINTER UP Command

COMMAND "C3C" [CR]
Move up Pointer of OSD Menu.
Detail
The behavior is the same as "▲" button of the projector and remote control.
Acceptable
Response
Unacceptable
6.36

POINTER DOWN Command

COMMAND "C3D" [CR]
Move down Pointer of OSD Menu.
Detail
The behavior is the same as the "▼"key on the projector and the remote control.
Acceptable
Response
Unacceptable
6.37

ENTER Command

COMMAND "C3F" [CR]
The behavior is the same as the "SELECT" key on the projector and the remote
control.
Detail
The projector does not show any OSD when it accepts this command and there
is no OSD shown.
Acceptable
Response
Unacceptable
[ACK] [CR]
"?" [CR]
[ACK] [CR]
"?" [CR]
[ACK] [CR]
"?" [CR]
[ACK] [CR]
"?" [CR]
[ACK] [CR]
"?" [CR]
[ACK] [CR]
"?" [CR]
14/19