Input Mode Read Command; Lamp Time Read Command; Setting Read Command - Sanyo PDG-DWL100 - WXGA DLP Projector Command Manual

PDG-DWL100 Basic Serial Command Specifications
Even if the temperature comes down during this process, the given Cooling Down process
is executed and it moves to Standby mode.
0û "21" [CR]
Status: Cooling Down in process after turned off due to lamp failure
When a projector is turned off because of lamp failure, it automatically starts Cooling Down
operation, in which the projector returns "21" [CR].
7.5

Input Mode Read Command

COMMAND "CR1" [CR]
Detail Get currently selected Input
Acceptable
Response
Unacceptable
7.6

Lamp Time Read Command

COMMAND "CR3" [CR]
Detail Get total lamp running hours
Acceptable
Response %1, %2
Unacceptable
7.7

Setting Read Command

COMMAND "CR4" [CR]
Detail Get screen setting status of Ceiling/Rear.
Acceptable
Response
Unacceptable
"%1" [CR]
"1" = Selected. HDMI
"2" = Selected. Computer 1
"3" = Selected. YPbPr 1
"4" = Selected. Scart
%1
"5" = Selected. Computer 2
"6" = Selected. YPbPr 2
"7" = Selected. Video
"8" = Selected. S-video
"?" [CR]
"%1" [CR]
Each lamp data follows in sequence with one space between
each of them.
%1 = lamp No.1
e.g.; "00410" [CR]
▪▪▪▪ → Lamp No.1 = 410 Hours
"?" [CR]
"%1" [CR]
"11" [CR] = Normal Screen Setting(Status: Desktop Front)
"10" [CR] = Picture is top/bottom reversed
(Status: Ceiling Rear)
%1
"01" [CR] = Picture is left/right reversed (Status: Desktop Rear)
"00" [CR] = Picture is top/bottom and left/right reversed
(Status: Ceiling Front
"?" [CR]
18 / 19
)