Overview; Serial Interface Specification; Transfer Specification; Connection - Sanyo PDG-DWL100 - WXGA DLP Projector Command Manual

PDG-DWL100 Basic Serial Command Specifications
1

Overview

1.1.
This specification defines projector control commands for the PDG-DWL100 series.
1.2.
The projector control commands are designed to remote-control a projector through RS-232C
and LAN from a computer.
2

Serial Interface Specification

2.1

Transfer Specification

Items
Synchronous system
Transmission Speed
Data Length
Parity
Stop Bit
Flow Control
2.1.1. Transmission speed: The initial setting value is 9600.
2.1.2. Transmission speed can be changed in service mode.
2.2

Connection

Dedicated serial cable that meets to following specifications must be used for the connection to
a computer and the projector.
Connect COM port of the computer to SERIAL PORT IN of the projector.
COM Port (COM1 or COM2) of a computer is specified by the control software of the computer.
Asynchronous
9600/19200
8 bits
None
1
None
PCPt
COM 1{ I
ÿ D - Sub 9 Pin ÿ
4/19
Specification
Projector Pt
Control Port
ÿ Mini 8 Pin ÿ