Installing The Power Distribution Board - Dell PowerVault NX3500 Hardware Owner's Manual

Installing the Power Distribution Board

CAUTION:
Many repairs may only be done by a certified service technician.
You should only perform troubleshooting and simple repairs as authorized in
your product documentation, or as directed by the online or telephone service
and support team. Damage due to servicing that is not authorized by Dell is not
covered by your warranty. Read and follow the safety instructions that came
with the product.
1 Unpack the new power distribution board assembly.
2 Align the power distribution board with the standoffs on the chassis.
See Figure 2-19.
3 Install the two screws that secure the power distribution board to the
chassis. See Figure 2-19.
4 Connect the power distribution cables to the system board (see "System
Board" on page 89) and fan cable connectors to the power distribution
board as shown in Figure 2-19.
5 Locate the hinged interior catches on either side of the shroud and align
and seat the power distribution board shroud, rotating it down and over
the shroud. See "Installing the Cooling Shroud" on page 63.
6 Orient the power distribution board with the fan markings on the cover
aligned to the fan modules and replace the shroud. See "Installing the
Cooling Shroud" on page 63.
7 Close the system. See "Closing the System" on page 53.
8 Reconnect the system to its electrical outlet and turn the system on,
including any attached peripherals.
88
Installing System Components