Installing The Srx210 Services Gateway On A Desk - Juniper SRX210 - HARDWARE GUIDE REV 3 Hardware Manual

SRX210 Services Gateway Hardware Guide
Related
Documentation

Installing the SRX210 Services Gateway on a Desk

74
SRX210 Services Gateway General Safety Guidelines and Warnings on page 127
Required Tools and Parts for Installing and Maintaining the SRX210 Services Gateway
on page 59
Preparing the SRX210 Services Gateway for Rack-Mount Installation on page 65
Adjusting the Power Supply Adapter Tray for the SRX210 Services Gateway for
Rack-Mount Installation on page 70
Installing the SRX210 Services Gateway on a Desk on page 74
Installing the SRX210 Services Gateway on a Wall on page 76
Follow these guidelines when installing the device on a desk:
You can install the SRX210 Services Gateway on a desk, table, or other level surface.
The device is shipped with the rubber feet attached. The rubber feet are necessary to
stabilize the device on the desk.
You can install the device in a horizontal or vertical position.
The vertical position requires the vertical installation kit, which consists of a vertical
installation stand with the rubber feet attached.
NOTE: The desk-mounting kit is not shipped with the device and must be
ordered separately.
To install the device in a horizontal position:
The horizontal position is the standard installation position and does not require the
vertical installation kit.
Make sure that the rubber feet are attached to the chassis.
1.
Place the device on a desk with the Juniper Networks logo embossed on the top cover
2.
facing up.
To install the device in a vertical position:
Place the device on a flat and level surface with the Juniper Networks logo embossed
1.
on the top cover facing up.
Attach the vertical stand to the right side of the chassis using the specified screws as
2.
shown in Figure 21 on page 75.
Copyright © 2010, Juniper Networks, Inc.