Configuring Syslog Collection (Nsm Procedure) - Juniper NETWORK AND SECURITY MANAGER 2010.4 - CONFIGURING INTRUSION DETECTION PREVENTION DEVICES GUIDE REV 01 Manual

Configuring Intrusion Detection and Prevention Devices Guide
Table 46: IDP Configuration: SNMP Settings
Setting
Enable SNMP
SNMP Read Only Community
SNMP Manager IP
SNMP Contact
SNMP Location
New SNMP allowed hosts
Related
Documentation

Configuring Syslog Collection (NSM Procedure)

82
To configure an SNMP agent for a single IDP device:
In the NSM Device Manager, double-click the IDP device to display the device
1.
configuration editor.
Click Report Settings.
2.
Add or modify the settings in the SNMP Settings grid as described in the Table 46 on
3.
page 82.
Click OK.
4.
Description
Enables forwarding to a network management system that reads SNMP.
Specifies a string. The SNMP read-only community string resembles a password used for the
exchange between the IDP device and the network management system.
Specifies the IP address of the SNMP server.
Specifies an e-mail address for the IDP administrator contact to be included in SNMP
communications. If the network management system encounters a problem with the SNMP
communication, it can use the contact information to follow up.
Specifies a location of the IDP device to be included in SNMP communications.
Specifies the network/host IP address and the network/host netmask for the agent.
Configuring Syslog Collection (NSM Procedure) on page 82
NSM Logs and Reports Overview on page 129
You configure syslog settings if you want to forward a copy of IDP logs to a syslog server.
You have the option of configuring NSM to forward a copy of its log collection to a syslog
server or configuring syslog settings for each IDP device.
To have all IDP logs sent to a Syslog server, select the check box and specify the syslog
server IP address. Then load the new configuration onto the sensor.
To configure syslog forwarding for NSM, see the NSM online Help.
To configure syslog forwarding for a single IDP device:
In the NSM Device Manager, double-click the IDP device to display the device
1.
configuration editor.
Click Report Settings.
2.
Copyright © 2010, Juniper Networks, Inc.