Disarming Diagnostics; Table Of Zones - Directed Electronics 1500ESP Owner's Manual

Directed electronics remote start alarm system owner's guide 1500esp

Hide thumbs Also See for 1500ESP:

Table of Contents

that input ceases, the security system will resume normal moni-

toring. For example, if your vehicle has an interior light exit delay

and you arm your security system before the interior light turns

off, you may hear a second Bypass Notification chirp. Once the

light turns off, however, the security system resumes normal

monitoring.

NOTE: Bypass Notification does not occur when the system is in Silent

Mode or if the notification chirps have been programmed by the installer

not to sound.

Disarming Diagnostics

Extra chirps that are heard when disarming the system are the

Tamper Alert. If four chirps are heard when disarming the system,

then the security system was triggered in your absence. If five

chirps are heard when disarming the system, a zone was triggered

so many times that the Nuisance Protection Circuitry

that zone. In either case, the status LED will indicate which zone

was involved (see Table of Zones section). The security system will

retain this information in its memory and chirp four or five times

each time it is disarmed, until the next time that the ignition is

turned on.

A zone is represented by the number of LED flashes used by the

system to identify a particular type of input. Standard input

assignments are listed in the following table, along with spaces to

write in any optional sensors or switches that have been installed.

1999 Directed Electronics, Inc.

™

has bypassed

Table of Contents