Disarming; High Security Disarm; Disarming Without A Transmitter - Directed Electronics 1500ESP Owner's Manual

Directed electronics remote start alarm system owner's guide 1500esp

Hide thumbs Also See for 1500ESP:

Table of Contents

Disarming

To turn off, or disarm the security system, press

again. You will

hear two chirps, and the parking lights will flash twice. If the

power locks are controlled by the system, the doors will also

unlock. The siren chirping either four or five times when disarming

indicates Tamper Alert, which is described in the Diagnostics

Section of this guide.

Your security system includes a High Security Disarm feature. After

6 seconds of trigger sequence, using the transmitter to disarm the

security system will only stop the trigger sequence (the siren will

stop and the parking lights will stop flashing). However, the sys-

tem will remain armed and the doors will stay locked. This is

extremely useful if you must stop the system from sounding, but

are unable to visually check the vehicle. This feature allows you to

silence and reset the security system when it is triggered, without

having to disarm the system.

If your remote transmitter is lost or damaged, you can manually

disarm your vehicle security system. To disarm the system without

a transmitter, you must have the vehicle's ignition key and know

where the Valet

switch is located. Be sure to check with your

installer at the time of installation for both the location and the

preset response (1-5 presses) of the Valet

switch.

1999 Directed Electronics, Inc.

Table of Contents