Disarming Diagnostics - Directed Electronics Automate 553 Owner's Manual

the security system ignores the input that was active when the
system was armed, until that input ceases. Three seconds after
that input ceases, the security system will resume normal moni-
toring. For example, if your vehicle has an interior light exit delay
and you arm your security system before the interior light turns
off, you may hear a second Bypass Notification chirp. Once the
light turns off, however, the security system resumes normal
monitoring.
NOTE: Bypass Notification does not occur when the system is in Silent
Mode or if the notification chirps have been programmed by the installer
not to sound.

Disarming Diagnostics

Extra chirps that are heard when disarming the system are the
Tamper Alert. If four chirps are heard when disarming the system,
then the security system was triggered in your absence. If five
chirps are heard when disarming the system, a zone was triggered
so many times that the Nuisance Protection Circuitry
that zone. In either case, the status LED will indicate which zone
was involved (see the following Table of Zones section). The sys-
tem will retain this information in its memory and chirp four or five
times each time it is disarmed, until the next time the ignition is
turned on.
22
™ has bypassed
1999 Directed Electronics, Inc.
©