ESP FEATURES AND CONTROLS
The ability to access the feature settings
of your amplifier is only possible with
the use of a Directed Electronics
Bitwriter
unit. Firmware version 1.8 or
®
later is required in the Bitwriter
Versions prior to 1.8 will not program
the amplifier.
MAIN FEATURES
1. T T u u r r n n - - o o n n d d e e l l a a y y - - 0.75, 1.00, 1.25,
1.75, 2.25, 2.75, or 3.25 seconds
is selectable. 2 2 . . 7 7 5 5 seconds is the
factory default setting.
2. A A n n t t i i - - t t h h e e f f t t - - On/Off/Reset Anti-Theft
Trigger. Selecting ON places the unit
in the alarm monitoring (amplifier
disable on loss of 12V) condition.
Off disables alarm monitoring.
Reset Anti-Theft Trigger allows the
amplifier to be unlocked from the
loss of 12V. O O f f f f is the factory
default setting.
To unlock the amplifier, use the
following procedure:
A A . . Plug the Bitwriter
®
the ESP ports and turn the
Bitwriter
®
ON.
B B . . Select A A n n t t i i - - T T h h e e f f t t from the menu.
i i . . Select A A n n t t i i - - T T h h e e f f t t R R e e s s e e t t from
the submenu.
i i i i . . Press W W r r i i t t e e twice.
1 1 2 2
C C . . Select A A n n t t i i - - T T h h e e f f t t from the menu
again.
i i . . Select O O f f f f from the submenu.
i i i i . . Press W W r r i i t t e e twice.
.
®
A "W W r r i i t t i i n n g g S S u u c c c c e e s s s s f f u u l l " message
will appear on the Bitwriter
display if the procedure was
successful.
3. V V a a l l e e t t m m o o n n i i t t o o r r i i n n g g - - Enable/Disabled
D D i i s s a a b b l l e e d d is the factory default
setting. The amplifier will not power
up if the alarm system is in Valet.
4. I I n n p p u u t t g g a a i i n n a a d d j j u u s s t t m m e e n n t t - - U U n n l l o o c c k k is
the
factory
Lock/Unlock, in the lock position
the gain adjustment located on the
top panel is software locked at the
input gain range that is selected.
5. I I n n p p u u t t g g a a i i n n r r a a n n g g e e - - 0.25–0.50,
0.50–1.25,
3.00–6.00 V, and 0 0 . . 2 2 0 0 – – 8 8 . . 0 0 0 0 V V
(factory default). This limits the
gain adjustment to the specified
into one of
range.
6. F F a a n n C C o o n n t t r r o o l l - - On/Auto/Off
This controls an external fan
connected to the fan port.
®
default
setting.
1.25–3.00,
or
© 2004 Directed Electronics, Inc