Top Panel Controls - Directed Audio 6 Owner's Manual

TOP PANEL CONTROLS

1. I I n n p p u u t t G G a a i i n n A A d d j j u u s s t t m m e e n n t t - Controls
amplifier sensitivity and is used to
match the input level of the amplifier
to the output level of the signal
source.
2. C C r r o o s s s s o o v v e e r r S S e e l l e e c c t t i i o o n n S S w w i i t t c c h h -
Controls the type of filter for the on-
board active crossovers. FLAT does
not attenuate any frequencies and is
for full-range speaker systems. HPF
attenuates low frequencies and is
used for mid-range speakers and
tweeters. LPF attenuates high
frequencies and is typically used for
subwoofers.
3. C C r r o o s s s s o o v v e e r r F F r r e e q q u u e e n n c c y y A A d d j j u u s s t t m m e e n n t t -
Adjusts the crossover point for the
on-board active crossovers.
FIGURE 3—AMPLIFIER CONTROLS 700/6 TOP
4
3
2
1
10
4. B B a a s s s s E E Q Q S S w w i i t t c c h h - - Adds 8 db of addi-
tional boost to channels five and six
output when active.
5. I I n n p p u u t t P P a a r r a a l l l l e e l l S S w w i i t t c c h h - Controls the
input signal to the indicated channels.
If the 3+4 switch is ON, channels
three and four will derive their signal
from channels one and two RCA jacks
and no input is needed. If the 3+4
switch is OFF, channels three and four
RCA jacks must have input. If the
5+6 switch is ON, channels five and
six will derive their signals from chan-
nels one through four RCA jacks and
no input is needed. If the 5+6 switch
is OFF, channels five and six RCA
jacks must have input.
5
© 2003 Directed Electronics, Inc