Esp Features And Controls - Directed Audio D2400 Owner's Manual

FIGURE 2—AMPLIFIER CONNECTIONS - REAR
D1200
D2400
FUSE
ESP FEATURES AND CONTROLS
® ®
These amplifiers incorporate an on-board
Directed ESP ® Engine. In addition to
allowing menu-driven parameter adjust-
ment*, operate with security products
from Directed Electronics to incorporate
advanced ESP2 features. Your dealer
can use a Bitwriter
®
version 2.0 or later to access these
parameters.
* * N N o o t t e e : : The ESP ®
obtained by using Bitwriter
3 pin ESP ® cable. While a
Bitwriter ® can only talk to one
ESP /ESP2 device at a time,
®
multiple amplifiers can be set to
respond to Arm/Disarm commands.
1 1 0 0
40A x 3
with Firmware
features are
and a
®
For the Bitwriter
the cable must have the same color
sequence at both ends of the cable. For
the Alarm to Amplifier, the Transmit and
Receive wires must cross from one end
Simply repeat the TX ID Learn
procedure for each amplifier. When
completed use a Y-cable to connect
the Alarm signals to both ampli-
fiers.
N N o o t t e e : : Prior to using the anti-theft or
valet features it is recommended
that the alarm be installed and its
functionality verified. Please consult
the install or operations guide for
the appropriate alarm.
to Amp connection,
®
© 2005 Directed Electronics, Inc. all rights reserved