Top Panel Controls; Top Panel Features - Directed Audio 1100d Owner's Manual

TOP PANEL CONTROLS

1. I I n n p p u u t t G G a a i i n n A A d d j j u u s s t t m m e e n n t t - Controls
the amplifier's sensitivity and is
used to match the input level of the
amplifier to the output level of the
signal source.
2. C C r r o o s s s s o o v v e e r r F F r r e e q q u u e e n n c c y y A A d d j j u u s s t t m m e e n n t t -
Adjusts the crossover point for the
on-board low-pass crossover.
3. S S u u b b s s o o n n i i c c F F r r e e q q u u e e n n c c y y S S w w i i t t c c h h - Sets
the cutoff point for subsonic
FIGURE 4—AMPLIFIER CONTROLS TOP
1

TOP PANEL FEATURES

Control Panel Cover
The gain and filter controls are located
under a control panel cover on top of
the amplifier. The control panel cover
must be removed to gain access to the
gain and filter controls.
10
frequencies below 30Hz. Frequen-
cies below 30Hz will be attenuated
by 24db per octave.
4. B B a a s s s s E E Q Q S S w w i i t t c c h h - Adds 8db of addi-
tional boost to the subwoofer
output when active.
5. S S u u b b P P h h a a s s e e S S w w i i t t c c h h - Changes the
phase of the subwoofer output by
180 degrees.
Remove/Install
Four Allen-head screws hold the control
panel cover to the amplifier top panel,
one at each corner. They can be
removed with the wrench supplied in
the hardware pack.
© 2002 Directed Electronics, Inc
2
3
4
5