Transfer Roller Replacement - Brother HL-2400C Service Manual

2.3

Transfer Roller Replacement

<Criterion of Replacement>
The transfer roller should be replaced at the same time as a new discharger unit
according to the periodical maintenance cycle set out in Table 6-4.
When time is due for replacement of the transfer roller, the following message
appears on the control panel.
<Purpose of Replacement>
To prevent the transfer efficiency declining due to deterioration of the transfer roller.
<Necessary Tools and Replacement Materials>
1) Two or three pieces of cotton cloth for cleaning.
2) Transfer roller (one unit)
<Work Procedures>
Sequence of Disassembling
1) After turning off the printer, unplug
the power cable from the power
outlet.
2) Open the rear access cover. (Fig.6-
18)
Sequence of Replacement
1) Lift the transfer roller lock lever to
release the right hand end of the
roller. The angle of lifting the lock
lever is approx. 80° from the
horizontal. (Fig.6-19)
LJ READY 001P T1
REPLACE 120K KIT
Rear Access Cover
Transfer Roller
VI-22
Fig.6-18
Lock lever
Fig.6-19