Brother HL-2400C Service Manual page 159

48 EACH IMAGE SET
This mode can reset the number of total pages of each color in the NVRAM whenever
NVRAM INITIAL is executed or the MCTL PCB is replaced.
Note: Do not perform this mode other than when replacing the MCTL PCB.
Description of Procedures
1) Press the Continue button after selecting
Screen (a) "EACH IMAGE SET".
2) Select the desired color to reset in EACH
IMAGE SET.
3) Use the Set or
digit.
Use the Continue button to input values to
the selected (blinking) digit.
Upon completing the input of the values, use
the Set or button to select SET on the LCD
and then press the select button to store the
set value.
4) Press the Font button to exit the EACH
IMAGE SET mode.
(a) (b)
(b) (c)
button to select the desired
(c) (d)
V-38
LCD Message
39 FACTORY MODE
a)
EACH IMAGE SET
48 IMAGE OF
b)
Y/M/C/K
48 IMAGE OF
c)
005432 P SET
48 IMAGE OF
d)
Y/M/C/K
39 FACTORY MODE
e)
DP CHECK
C