Check The Installation; Connect To Power And Check The Leds - NETGEAR XSM7224S - ProSafe 10 Gigabit Stackable Hardware Installation Manual

2. Use the provided Phillips head screws to fasten the brackets to the sides of the
switch.
Figure 1. Installing the Switch in a Rack
3. Tighten the screws with a No. 1 Phillips screwdriver to secure each bracket.
4. Align the bracket and rack holes. Use two pan-head screws with nylon washers to
fasten each bracket to the rack.
5. Tighten the screws with a No. 2 Phillips screwdriver to secure the switch in the rack.

Check the Installation

Before you apply power, perform the following checks:
1. Inspect the equipment thoroughly.
2. Verify that all cables are installed correctly.
3. Check cable routing to ensure that cables are not damaged and will not create a safety
hazard.
4. Be sure that all equipment is mounted properly and securely.

Connect to Power and Check the LEDs

The switch does not have an On/Off switch. The only way to apply or remove power is to
connect or disconnect the power cord. Before you connect the power cord, select an AC
outlet that is not controlled by a wall switch (which can turn off power to the switch).
After you select an appropriate outlet, follow these steps to apply AC power.
12 | Chapter 2. Hardware Installation
Managed Stackable Switch XSM7224S
mounting
bracket