NETGEAR XSM7224S - ProSafe 10 Gigabit Stackable Hardware Installation Manual page 13

Managed Stackable Switch XSM7224S
1. Connect one end of the AC power adapter cable to the rear of the switch, and the other
end to a grounded 3-pronged AC outlet.
2. Check the Power LED on the front panel of the switch. The LED should light up in the
following sequence:
• The LED turns yellow as the switch runs a Power-On Self-Test (POST).
• If the switch passes the test, the LED turns green. The switch is working and ready to
pass data.
• If the POST fails, the Power LED blinks yellow.
If the Power LED does not light up, check that the power cable is plugged in correctly and
that the power source is good. For help with troubleshooting, see Chapter 3.3,
"Troubleshooting."
SFP+ / SFP Modules
SFP+ and SFP modules (sold separately) can be inserted directly into the switch's ports.
Figure 2. SFP+ SFP Modules
• AXM761 - SFP+ module with an LC connector that is compatible with the IEEE 802.3ae
(10GBase-SR)
• AXM762 - SFP+ module with an LC connector that is compatible with the IEEE 802.3ae
(10GBase-LR)
• AXM763 - SFP+ module with an LC connector that is compatible with the IEEE 802.3aq
(10GBase-LRM)
• SFP+ module with an LC connector that is compatible with the IEEE 802.3aq
(10GBase-LRM) and IEEE 802.3ae (10GBase Ethernet) standards.
• AGM731F - SFP module with LC connector, compatible with the IEEE 802.3z
1000Base-SX standard.
• AGM732F - SFP module with LC connector, compatible with the IEEE 802.3z
1000Base-LX standard.
• SFP or SFP+ module with LC connector, compatible with the IEEE 802.3z 1000Base-X
standard.
1. insert the module into the switch port.
Chapter 2. Hardware Installation | 13