NETGEAR XSM7224S - ProSafe 10 Gigabit Stackable Hardware Installation Manual page 6

Managed stackable switch
Hide thumbs Also See for XSM7224S - ProSafe 10 Gigabit Stackable:
Table of Contents

Advertisement

l
Table 1. LED Descriptions for XSM7224S
LED
ID
Stack Master
Power
Fan
10GBT Ports
(2 LEDs per port)
SFP+ Ports
1 SPD/Link/ACT
(
LED per port)
6 |
Chapter 1. Introduction
Description
This is the stack member ID (1–99) that the software assigns to the switch.
Green: The switch acts as a master unit in a stack of XSM7224S series
switches.
Off: The switch acts as a slave unit in a stack of XSM7224S series switches.
Solid green: The power module is present, is supplying power to the switch, and
is working normally.
Solid yellow: The system is in boot-up stage.
Blinking yellow: Power module is present but has failed.
Off: Power is disconnected.
Solid green: The fan is operating normally.
Solid yellow: The fan has failed.
Off: No fan is detected.
Right side LED
10/100M Link/ACT LED:
Off: No 10/100M link is established on the port.
Solid yellow: A valid 10/100M link is established on the port.
Blinking yellow: The port is transmitting or receiving packets
Left side LED
1G/10G Link/ACT LED:
Off: No 1G/10G link is established on the port.
Solid Green – A valid 10Gbps link is established on the port.
Blinking Green – Packet transmission or reception is occurring on the port at
10Gbps.
Solid Yellow – A valid 1000Mbps link is established on the port.
Blinking Yellow – Packet transmission or reception is occurring on the port at
1000Mbps.
Note: If port 21–24 media is changed to SFP+, the RJ-45 LEDs change to OFF
status.
Off: No SFP/SFP+ module link is established on the port.
Solid green: A valid 10Gbps SFP+ module link is established on the port.
Blinking green: The port is transmitting or receiving packets at 10Gbps.
Solid yellow: A valid 1Gbps SFP module link is established on the port.
Blinking yellow: Packet transmission or reception is occurring on the port at
1Gbps.
Note: If port 21–24 media is changed to copper, the SFP+ LEDs change to Off
status.
Managed Stackable Switch XSM7224S
at
10/100Mbps.

Advertisement

Table of Contents
loading

Table of Contents