NETGEAR XSM7224S - ProSafe 10 Gigabit Stackable Hardware Installation Manual page 18

Fan Tray
Removing an XSM7224S Switch Fan Tray
The fan tray has a hot swap capability. It is not necessary to remove
Note:
the AC power when removing the fan tray.
To remove the fan tray, follow these steps:
1. Loosen the two captive screws on the fan tray.
2. Remove the fan tray from the fan tray slot by pulling on the captive screws.
Figure 6. Fan Tray Removal
Installing an XSM7224S Switch Fan Tray
To install fan tray, follow these steps:
WARNING!
When inserting a fan tray into the switches, do not use
unnecessary force. Doing so can damage the connectors on the
rear of the fan tray and on the midplane.
1. Insert the new fan tray module into the fan tray module slot, and gently push the module
into the slot.
2. Align the two captive screws with the screw holes in the switch's back panel.
3. Using a screwdriver, gently tighten the captive screws.
18 | Chapter 2. Hardware Installation
Managed Stackable Switch XSM7224S