Table of Contents
Advertisement
WIRING
CAUTION: Disconnect electrical power when wiring power venter
Wire the venter motor and controls in accordance with the National Electrical Code, manufacturer's recommendations
and/or applicable local codes. Units must be grounded. Check ground circuit to make certain that the unit has been
properly grounded. The wiring should be protected by an overcurrent circuit device rated at 15 amperes. CAUTION must
be taken to ensure that the wiring does not come into contact with any heat source. All line voltage and safety control
circuits, between the venter and the appliance, MUST be wired in accordance with the National Electrical Code for class
one wiring or equivalent methods. Route the venter motor and control wiring with an appropriate wiring method. Refer to
Wiring Diagrams A and B.
L
V
W
I
OW
OLTAGE
IRING
NSTRUCTIONS
1.
Route the appliance's vent damper cable to the CK-41P. Plug the cable into the receptacle located inside the CK-
41P using the supplied plastic knockout grommet (if the cable does not have a conduit connector). (See Diagram A)
2.
Connect the CK-41P's pre-wired damper cable to the vent damper (See Diagram A). Snap the end of the flexible
conduit into place on the vent damper conduit bracket.
L
V
W
I
INE
OLTAGE
IRING
NSTRUCTIONS
1. Verify that the circuit to be supplying power to the CK-41P is disconnected.
2. Connect the CK-41P green grounding wire to the circuit's ground wire. Verify that the control box is properly
grounded.
3. Connect 120 volts hot power source wire to terminal L1 on CK-41P.
4. Connect 120 volts neutral power source wire and white wire from venter motor to terminal N on the CK-41P.
5. Connect black wire from venter motor to terminal M on the CK-41P.
Refer to the SWG Venter installation instructions for setting system air flow.
F
B
:
OR
OILERS
:
Page 3
Diagram A
Advertisement
Table of Contents
