To Start The Self-Clean Cycle - Kenmore 4813 - Elite 30 in. Double Wall Oven Use & Care Manual

Self-Cleaning
To Start the Self-Clean Cycle
The FLEX CLEAN @ pad controls the Self-Cleaning feature. If you are
planning to use the oven directly after a self-clean cycle remember to allow
time for the oven to cool down and the oven door to unlock. This normally
takes about one hour. So a 3 hour self-clean cycle will actually take about
4 hours to complete.
*It is recommend to use a 2 hour self-clean cycle for light soils, a 3 hour
cycle for average soils, and a 4 hour cycle for heavy soils (to assure
satisfactory results).
INSTRUCTIONS
To avoid possible burns use
care when opening the oven door after the
Self-Cleaning cycle. Stand to the side of the
oven when opening the door to allow hot air or
steam to escape,
DO NOT force the oven door
open. This can damage the automatic door
locking system. Use caution and avoid possible
burns when opening the door after the Self-
Cleaning cycle has completed. The oven may
still be VERY HOT.
PRESS DISPLAY
To tart an immediate Self-Cleaning cycle or to set a
Delay Start time of 4:30 and shut-off automatically
(example provided is a default 3 hour Self-Clean
Cycle)
1. Be sure the clock is set with the correct time of day and the
oven door is closed,
2. Press (.u_.
3. Press _. "UPPER" and "CLEAN" will flash and "3:00 HR"
will show in the display (Fig. 1). The control will automatically
clean for a 3 hour period (default self-cleaning cycle time).
Note: If a 2 or 4 hour clean time is desired, press (_ @
@ for 2 hour or press @ @ @ for a 4 hour clean
time. Set the cleaning time based on the amount of soil: light,
medium or heavy (* See above).
4.
Press
_A_.
The "DOOR LOCKED" icon will flash; "UPPER",
"CLEAN" icon and the letters "CLn" will remain on in the
display (Fig. 2).
5. As soon as the control is set, the motor driven oven door lock
will begin to close automatically. Once the door has been
locked the "DOOR LOCKED" indicator light will stop flashing
and remain on. Also, the oven icon will appear in the display
(Fig. 3).
Note: Allow about 15 seconds for the oven door to lock.
Fig. 1
Fig. 2
Fig. 3
Fig. 4
Fig. 5
Fig. 6
Note: If the optional delay Self=Clean feature is desired, finish
step 6-9. if Self-Clean is started immediately skip the
remaining steps and continue with "When the Self-Clean cycle
is done" on the following page.
6. Press @ (Fig. 4). Enter the desired start time using the
number pads @ @ @ (Fig. 5).
7. Press @. "CLEAN", "DELAY", "LOCK", "UPPER" and
"DOOR" will be displayed (Fig. 6).
9. The control will start the self-cleaning at the set start time, for
the period of time previously selected. At that time, the icon
"DELAY" will go out.
@
d Q@
28