Download  Print this page

Kenmore 4813 - Elite 30 in. Double Wall Oven Use & Care Manual Page 33

Use and care guide.
Hide thumbs

Advertisement

Before You Call
Solutions to Common Problems
Before you call for service, review this list. It may save you time and expense. The list includes common occurrences that
are not the result of defective workmanship
or materials in this appliance.
OCCURRENCE
POSSIBLE
CAUSE/SOLUTION
Oven Control Beeps and Displays
any F code error (example
F11).
Electronic control has detected a fault condition. Press STOP to clear the
display and stop the beeping. Reprogram the oven. If a fault reoccurs, record
the fault number. Press STOP and call Sears or another qualified servicer.
d=O is displayed.
The door was left open and controls set for self-cleaning cycle. Simply close
the door.
Range not level.
Bad cooking
results.
Place oven rack in center of oven. Place a level on the oven rack. Contact
installing agent if rack and cabinet cutout flooring are not level.
Kitchen cabinet misalignment may make oven appear to be not level. Be sure
cabinets are square and level. Contact cabinet maker to correct problem.
Entire over= does not operate.
When the oven is first plugged in, or when the power supply to the oven has
been interrupted, the display will flash. The oven cannot be programmed until
the clock is set.
Be sure electrical cord is securely connected into the electrical junction box.
Cord/plug is not installed and/or connected. Cord is not supplied with oven.
Contact Sears or another qualified servicer.
Service wiring not complete. Contact Sears or another qualified servicer.
Power outage. Check house lights to be sure. Call your local electric company.
Short in cord/plug. Replace cord/plug.
Controls are not set properly. See instructions under Setting Oven Controls
to set the controls.
House fuse has blown or circuit breaker has tripped immediately following
installation. House fuse may not be fully engaged. Check fuse and screw or
engage circuit breaker securely.
House fuse has blown or circuit breaker
has tripped after the oven has been
installed and previously operating. Sears or another qualified servicer.
Oven light does not work.
Burned-out or loose bulb. Follow the instructions under Changing
Oven Light
to replace or tighten the bulb.
Far= noise during cooking
operation.
A cooling fan may automatically turn on and off to cool internal parts. This is
normal, and the fan may continue to run even after oven is turned off.
On 30" Double Wall Ovens, in self-clean mode, the blower in both ovens will
start when using one of the ovens.
33

Advertisement

Table of Contents

Comments to this Manuals

Symbols: 0
Latest comments: