Editing Macros - Kurzweil K2000 - MUSICIANS GUIDE Musician's Manual

Disk Mode
Macros
Func:VIEW|MACRO|||Sel:0/4||||Index:|||1|
||||||||||||||||||||||||||||||||||||||||
||||||||||||||||||||||||||||||||||||||||
|5:\ANALOG\MULTIVOX.KRZ||||||||200:F:|||
|5:\ANALOG\NOISE.KRZ|||||||||||200:F:|||
|5:\ANALOG\RESONANT.KRZ||||||||200:F:|||
|5:\ANALOG\SYNAPSE.KRZ|||||||||200:F:|||
|||||||||||||||||||||||||||||||||||Exit|
The only function of this dialog is to view the Macro list entries stored in a Macro Þle. This
feature is useful when, for instance, you are about to delete a Macro Þle and want to know what
information is contained in the Þle before you remove it from the drive.

Editing Macros

The in-memory Macro Table can be edited from the Macro page. You can select one or more
Macro entries and do any of the following operations to them:
1. Change the Drive ID.
2. Change the Bank and Mode settings.
3. Delete the selected Macro entries.
To edit a Macro Þle already saved on your disk, it is necessary to Þrst load the Macro Þle into
the in-memory Macro. If you recall, this is done by the following procedure:
Making sure that Macro Record mode is enabled, go to the Load function, highlight the Macro
Þle you wish to edit, and then either select certain entries from the Macro Þle (by pressing Open
to get to the Load Macro page), or just press OK to load the entire Macro Þle. When you see the
following display, press the Macro soft button, so that the K2vx will not try to load the Þles
listed in the Macro.
||||||||||||||||||||||||||||||||||||||||
||||||||||||||||||||||||||||||||||||||||
||||||||||||||||||||||||||||||||||||||||
|Load|this|macro|as:specified|||||||||||
||||||||||||||||||||300...399|||||||||||
||||||||||||||||||||400...499|||||||||||
||||||||||||||||||||500...599|||||||||||
Insert||||||||||||||||Macro|||OK||Cancel
If you want, you can rebank the Macro on the way in by scrolling the bank list to something
other than "speciÞed". Similarly, if you override the load mode, it will be reßected in the in-
memory Macro Table as well.
To edit entries from the Macro Table, return to the Macro page. For this example we will edit all
the entries at once (like other similar dialogs, if you only are concerned with one list entry, it
does not need to be explicitly selected with the Select soft button.) You can use the following
double-presses to select and deselect all entries in the list:
Left/Right cursor double-press -> Select All Macro Entries
Up/Down cursor double-press -> Clear All Selections
13-50