Kurzweil K2000 - MUSICIANS GUIDE Musician's Manual page 380

Front Panel
Front Panel Quick Reference
Setup modeÑ
Quick Access modeÑ
Effects modeÑ
MIDI modeÑ
Master modeÑ
Song modeÑ
Disk modeÑ
Soft Buttons
Functions change depending on current display page. Function of each button is displayed on
bottom line of display.
EXIT Button
Press to leave various editors. If youÕve made any changes while in the editor, you will be
prompted to save them.
Cursor Buttons
Press the corresponding button to move the cursor up, down, left, or right in the display.
Different parameter values will be highlighted as buttons are pressed.
Alpha Wheel
For data entry. Rotate clockwise to increase value of currently selected parameter,
counterclockwise to decrease.
Plus / Minus Buttons (- and +)
Under the Alpha Wheel. Press to increase or decrease the value of the currently selected
parameter by the smallest possible amount.
Alphanumeric Pad
For Numeric Characters
Enter the value numerically instead of using the Alpha Wheel or Plus/Minus buttons. Press
ENTER when Þnished. Press CANCEL to restore a parameter to its previous value. Pressing
CLEAR is equivalent to pressing 0 without pressing ENTER.
For Alphabetic Characters
When naming objects, you can use the alphanumeric pad to enter letters instead of numbers. If
youÕre renaming a program, for example, just position the cursor under the character you want
20-2
Éenters the Setup Editor, where you can edit the currently selected
setup. Chapter 7 in the Performance Guide describes the Setup Editor.
Éenters the Quick Access Editor, where you can change the pro-
gram or setup assigned to the bank slot that was selected when you
entered the Quick Access Editor. See Chapter 8 in the Performance
Guide .
Éenters the Effects Editor, where you can edit the currently selected
effects preset. Chapter 9 in the Performance Guide explains the Effects
Editor.
Éenters the Velocity Map or Pressure Map Editor if the Velocity or
Pressure Map parameter is selected on either the XMIT page or the
RECV page. See Chapter 17 in the Performance Guide . Enters the Pro-
gram Editor if the Program parameter is selected on the CHANLS
page. See Chapter 6 in the Performance Guide .
Éenters the Velocity Map, Pressure Map, or Intonation Table Editor
if the VelTouch, PressTouch, or Intonation parameter is selected.
Éenters the Song Editor. The Song Editor is discussed in Chapter 12
in the Performance Guide . Enters the Program Editor if the Program
parameter is highlighted when Edit is pressed.
Éhas no effect.