The Receive (Recv) Page - Kurzweil K2000 - MUSICIANS GUIDE Musician's Manual

The Receive (RECV) Page

Press RECV to select the Receive page, where you deÞne the K2vxÕs response to incoming MIDI
signals.
MIDIMode:RECEIVE||||||||||||||||||||||||
BasicChannel: 1|||||||| |SysExID:|||0|||||
MIDI|Mode|||:Multi|||||SCSI|ID:|||6|||||
AllNotesOff|:Normal||||BendSmooth:On||||
ProgChgType|:Extended||LocalKbdCh:None||
VelocityMap:|1|Linear||BankSelect:Ctl|32
Pressu r eMap:| 1 |Linea r ||PowerMode|: U ser||
XMIT|| | RECV|| | CHANLS | PrgChg | RsetCh |Panic
PARAMETER
BASIC CHANNEL
MIDI MODE
ALL NOTES OFF
PROGRAM CHANGE TYPE
VELOCITY MAP
PRESSURE MAP
SYSTEM EXCLUSIVE ID
SCSI ID
BEND SMOOTH
LOCAL KEYBOARD CHANNEL
BANK SELECT
POWER MODE
Basic Channel
The basic channel determines which channel will always be available to receive MIDI
information. Depending on the MIDI receive mode (below), the Basic channel may be the only
receiving channel, or one of several.
MIDI Receive Mode (MIDI Mode)
The MIDI Mode parameter determines the MIDI receiving capabilities of the K2vx. When set to
Omni, the K2vx responds to incoming MIDI events on all MIDI channels, and plays them on
the current channel. This is normally used for diagnostic purposes only.
At a setting of Poly, the K2vx will respond only to events that are sent on the same channel as
the K2vxÕs current MIDI channel (the one displayed on the top line of the Program mode page).
In Poly mode, the currently selected channel is always the basic channel, so if you change
channels, the basic channel changes accordingly.
With a value of Multi (the default), the K2vx will respond to events on all active channels. This
is the mode youÕll use when youÕre driving the K2vx with a sequencer, since you can play a
different program on each channel. At this setting, you can turn individual channels on and off
(on the CHANLS page, described later in this chapter).
All Notes Off
If this parameterÕs value is set to Normal, the K2vx will respond to All Notes Off messages
received over MIDI. Set to Ignore, these messages will be ignored. If youÕre using a Roland
product as a MIDI controller for your K2vx, youÕll want to set the value of this parameter to
Ignore. This is because Roland products occasionally send an All Notes Off message even when
notes should normally be sustained. You might Þnd all your sustains missing from your
RANGE OF VALUES
1 to 16
Omni, Poly, Multi
Normal, Ignore
(See below)
Velocity Map list
Pressure Map list
0 to 126
0 to 7
On, Off
None, 1 to 16
0 only, 32 only, Ctl 0, Ctl 32
User, Demo
MIDI Mode
The Receive (RECV) Page
DEFAULT
1
Multi
Normal
Extended
1 Linear
1 Linear
0
6
On
None
Ctl 32
User
10-5