Page 1
Emergency stop Oil pressure warning lamp (diesel) Vol tmeter Frequency meter, ON/OFF Fuel gauge DYWAPAC 0-10200-4 Dynapac Heavy Equipment AB PO Box 504.S-371 23 KARLSKRONA•SWEDEN Tet. 0455-229 30.Telex 43041 dynkar Telecopier 0455-295 39 We reeerve right to change .pecilicatbn. without notice...
Page 2
CAUTION WHEN FUELLING MACHINE: - SHUT DOWN ENGINE - NO SMOKING - GROUND FILLER AGAINST TANK NECK TO AVOID A SPARK. DO NOT MODIFY THIS ROLLER IN ANY WAY WHICH WILL AFFECT SAFETY WITHOUT DYNAPAC WRITTEN APPROVAL. CA 25 0-10200...
Page 3
BEFORE STARTING Ensure that daily maintenance has been carried out (see the Maintenance Instructions). Check that the battery master switch (1) is in the ON position. Check also that the engine air intake obstructed. Apply the handbrake by pulling up the lever upwards.
Page 4
GOVENOR (only applies to the CA 25 A) The roller is fitted with an adjustable govenor that may be disengaged during transport driving. Fig. Govenor Disengaged Limi ted speed STARTING Ensure that the stop control (12) has been pressed in fully (applies only to Deutz and Fig.
Page 5
Press in the button on the throttle (17) and pull the throttle to 1/4 full throttle. Ire e 7 Instrument panel Temp. gauge - hydr. pressure Temp. gauge - coolant warning lamp cleaner warning lamp Vol tme ter Throttle Fuel gauge Supply switch Turn the supply switch (27) to Check...
Page 6
DRIVING Move the throttle (11) until the engine speed is 2400 rpm. Carry out fine adjustment by turning control Anticlockwise to increase speed. Clockwise reduce speed. Ensure that steering performs correctly, turning steering wheel once to the left once to the right, with roller...
Page 7
Vibrating/driving Do not engage vibration when the roller is sta- tionary. Setting - high/low amplitude Use the switch (7) to select high/ low amplitude. N.B. Avoid to move the amplitude selector switch (7) when vibration is engaged, Switch vibration wait a few seconds before throwing...
Page 8
PARKING Park roller road. NEVER LEAVE THE ROLLER If the roller is parked on sloping ground, block THEENGIN wheels/ drum. RUNNING. LIFTING INSTRUCTIONS Before lifting the roller, lock the articulated joint, to prevent rotation about it. Swing out the arm and lock it as shown in Fig.
Need help?
Do you have a question about the CA25 and is the answer not in the manual?
Questions and answers