Table of Contents
Advertisement
4.
A message is displayed stating that the mouse and keyboard are reset.
5.
Complete one of the following steps:
•
Click OK to close the message field.
•
Click X or press Escape to exit without sending a Reset command to the mouse
and keyboard.
Scanning the switching system
In scan mode, the appliance automatically scans from port to port (target device to target device).
Use scan mode to monitor the activity of up to 16 target devices, and to specify which target
devices to scan and the number of seconds that each target device will be visible. The scanning
order is determined by placement of the target device in the list, which is always shown in scanning
order. You can choose to list the target devices by name, eID number, or port number by clicking
the corresponding button.
To add target devices to the scan list, complete the following steps:
1.
Click Setup > Scan. The Scan window opens
.
Figure 3.12: Scan window
2.
The window contains a listing of all target devices that are attached to the appliance. To select
target devices to be scanned, complete one of the following steps:
•
Select the check box next to the target devices that you want to scan.
•
Double-click on a target device name or port.
•
Press Alt and the eID number of the target device that you want to scan. You can select up to
16 target devices from the list.
3.
In the Time field, type the number of seconds (from 3 to 255) of time before the scan moves to
the next target device in the sequence.
4.
Click OK.
Chapter 3: Basic operations
35
Advertisement
Table of Contents
