Figure 3.14: Diagnostics Window; Table 3.6: Diagnostic Test Details - IBM 17351GX Installation And User Manual

Local 2x8 console manager
Hide thumbs Also See for 17351GX:
Table of Contents

Advertisement

The Diagnostics window opens. The top section of the window opens the hardware tests. The
bottom portion divides the tested CO cables into three categories: On-line, Offline or Suspect. CO
cables might be listed as offline while being upgraded.

Figure 3.14: Diagnostics window

Next to each item that will be tested, you will see a pass (green circle) or fail (red x) symbol to the
left of each item as that test finishes. The following table details each of the tests.

Table 3.6: Diagnostic test details

Test
Firmware CRCs
LAN Connection
On-line CO cables
Offline CO cables
Suspect CO cables
To run diagnostic tests, complete the following steps:
1.
Click Commands
be disconnected.
2.
Click OK to begin diagnostics.
3.
All users are disconnected and the Diagnostics window opens.
4.
As each test is finished, a pass (green circle) or fail (red x) symbol is visible. The test is com-
plete when the last test symbol is visible.
Description
Reports on the condition of the main board RAM.
Reports on the condition of the LAN connection.
Indicates the total number of currently connected and turned on CO cables.
Indicates the number of CO cables that have been connected successfully in
the past and are turned off.
Indicates the number of CO cables that have been detected, but are either
unavailable for connection or have dropped packets during the ping tests.
Run Diagnostics. A warning message indicates that all users will
>
Chapter 3: Basic operations
37

Advertisement

Table of Contents
loading

Table of Contents