Mount The Switch - HP 1800 24G - ProCurve Switch Installation And Getting Started Manual

Installing the Switch
Installation Procedure

3. Mount the Switch

The switch can be mounted in these ways:
■
■
■
Rack or Cabinet Mounting
The switch is designed to be mounted in any EIA-standard 19-inch telco rack
or communication equipment cabinet. Note that the mounting brackets have
multiple mounting holes and can be rotated allowing for a wide variety of
mounting options.
W A R N I N G
For safe operation, please read the "Installation Precautions" on
page 2-2
E q u i p m e n t
The screws supplied with the switch are the correct threading for standard
C a b i n e t EIA/TIA open 19-inch racks. If you are installing the switch in an equipment
cabinet such as a server cabinet, use the clips and screws that came with the
N o t e
cabinet in place of the screws that are supplied with the switch.
Complete step 1. Then, plan which four holes you will be using in the cabinet
and install all four clips and partially install the two bottom screws, as
described in step 2. Then proceed to step 3.
1.
8 mm
M4 screws
2-6
in a rack or cabinet
on a horizontal surface
on a wall
and page 2-3, before mounting the switch.
Use a #1 Phillips (cross-head) screwdriver and attach the mounting
brackets to the switch with the included 8-mm M4 screws.