Brother 1920CN - Color Inkjet - Fax Service Manual page 69

n n
Reassembling Notes
• Route the panel harness and CCD HP sensor harness through the three notches, then tape
them as illustrated on the previous page.
• When replacing the CCD flat cable with a new one, be sure to arrange the new cable as
illustrated below, then route it along the positioning rib as shown on the previous page.
• Set the CCD motor back into place with its connector side facing up as shown on page IV-21.
When securing the motor with screws "d," be sure to secure the scanner grounding wire also as
shown on page IV-21.
• Route the CCD motor harness and scanner grounding wire as illustrated below.
• Set the CCD lock in the release (forward) position. If the CCD lock is placed in the lock
position, the CCD home positioning will fail in the next powering-up sequence. If this happens,
turn the CCD lock to the release position.
IV - 23