Web Installation And Configuration - Novell OPEN WORKGROUP SUITE SMALL BUSINESS EDITION 2.0 - INSTALLATION AND ADMINISTRATION GUIDE 5-02-2008 Administration Manual

5 On the Network Configuration window, if you want to change any of the network settings,
6 If you receive an IP address of https://127.0.0.1:8181 or https://:8181 instead of a valid IP

2.1.2 Web Installation and Configuration

IMPORTANT: You must begin your component download with eDirectory
two software components help you to manage many of the remaining components.
If you want to install GroupWise and MailScanner on the same server, use the Add/Remove function
to add MailScanner only after GroupWise is installed. Adding these two applications simultaneously
at the initial install might cause the GroupWise install to fail.
1 Type the link supplied at the end of your server installation in your Web browser and press
2 The first page you see is the End User License Agreement (EULA). Read through the
3 The next page is Network Settings. Verify the settings or add the correct information.
4 After you have specified the correct information, click Next.
5 You are then advanced to the License Key page. Specify your contact e-mail address and the
6 Click Check for Updates. If updates are found, select Install Updates. After the check is
20 Novell Open Workgroup Suite Small Business Edition 2.0 Administration and Installation Guide
click Change and select the setting you want to modify. If you do not want to make any
changes, click Next.
You are then presented with an IP address at the server prompt so you can move to the browser-
based portion of the installation and configuration. Make a note of the IP address; you need it to
access the Web site where you continue the installation. You have now completed the base
installation of the server.
address, DHCP is not functioning. Complete the following steps:
6a Verify that you are connected to the network with your DHCP server.
6b At the command line, log in as root without a password. The default password is
novell.
6c Enter the following command: /etc/init.d/network restart. You can also
enter rcnetwork restart
Enter to bring up the first page of the Web installation.
agreement and click I Agree to advance to the next page.
IP Address: The address should be the one from the initial setup of your server operating
system. Verify that this is accurate.
Netmask: Verify the netmask from your network.
Gateway: Verify the gateway from your network.
DNS Entry: Verify the IP address of your DNS server.
Host: Specify a name for your server. The hostname should be the same as your server.
You should not include special characters in the name of your server.
Domain: The Domain should match the name of your Internet domain name.
license keys that were provided to you, then click Next.
complete, click Next.
and iManager. These
TM