Novell LINUX ENTERPRISE SERVER 10 SP1 - ARCHITECTURE-SPECIFIC INFORMATION 15-03-2007 Supplementary Manual page 44

Network
Hard Disk
You are then directed to start the VNC client. See
VNC Can Begin"
Example 2.1 The Installation over VNC Can Begin
starting VNC server...
a log can be found in /tmp/vncserver.log ...
*** *** You can connect to 192.168.0.154, display :1 now ***
(When YaST2 is finished, close your VNC viewer and return to this
window.)
Start the VNC client with the displayed parameters (192.168.0.154:1 in this example)
and enter the VNC password (suseinst in this example). The graphical interface of
VNC appears and YaST starts a few seconds later.
Additional Steps
Proceed with Chapter 3, Installation with YaST (↑Installation and Administration) to
start the installation of the software.
38 Architecture-Specific Information
Allows the installation from an NFS share. The necessary network parameters
are requested along with the hostname or IP address of the NFS server. Also
enter the path to the NFS share.
Use this when the installation files are available on another hard disk. Enter
the device name including the partition and the path to the installation files
(for example, /dev/sdb1 and /suse). Before the system accesses the hard
disk, the network parameters for the installation over VNC are requested for
input.
(page 38).
Example 2.1, "The Installation over