Preparing An Installation On Ibm Js20/Js21 Blades - Novell LINUX ENTERPRISE SERVER 10 SP1 - ARCHITECTURE-SPECIFIC INFORMATION 15-03-2007 Supplementary Manual

2.2.6 Booting from the Network Source
Select an ethernet device that has access to the installation source (6 in this example).
2.2.7 Additional Steps
Proceed as described in Chapter 3, Installation with YaST (↑Installation and Adminis-
tration) to begin installing the software with linuxrc and YaST.
2.3 Preparing an Installation on IBM
JS20/JS21 Blades
This section describes the preparatory steps for the installation of SUSE® Linux Enter-
prise Server on JS20/JS21 Blades. It covers installation using the CD-ROM drive of
the BladeCenter and using the network.
2.3.1 Creating a Network Installation Source
Create a network installation source if SUSE Linux Enterprise Server should be installed
over a number of partitions. This provides the advantage that no CDs need to be changed
during installation. The same source can also be used for the concurrent installation of
various systems. Configuration of a network installation source is described in Sec-
tion 4.2.1, "Setting Up an Installation Server Using YaST" (Chapter 4, Remote Instal-
lation, ↑Installation and Administration).
2.3.2 Hard Disk Storage Space
Ensure that enough hard disk storage space is available for the installation of SUSE
Linux Enterprise Server. It is recommended to use a dedicated hard disk.
2.3.3 Notes and Information
Introductory Information:
18 Architecture-Specific Information