Novell LINUX ENTERPRISE SERVER 10 SP1 - ARCHITECTURE-SPECIFIC INFORMATION 15-03-2007 Supplementary Manual page 15

Figure 2.2 HMC: Managed System I/O Devices
Now insert the SUSE Linux Enterprise Server CD1 or DVD1 in the drive.
Procedure 2.2 Assigning a Network Device to an LPAR
1 Open the HMC application and go to Server and Partition > Server Management.
2 From the available servers, open the server and partition to install.
3 Right-click the profile to use for installation and select Properties—see
"HMC: Server Management—Properties"
4 In the Logical Partition Profile Properties dialog, select the Physical I/O tab.
5 From Managed system I/O devices, select PCI 10/100/1000Mbps Ethernet UTP
2-port from the bus where it is installed. Then click Add as required.
If you plan to install using a virtual ethernet adapter, refer to the IBM documen-
tation.
(page 8).
Figure 2.1,
Preparation 9