Novell LINUX ENTERPRISE SERVER 10 SP1 - ARCHITECTURE-SPECIFIC INFORMATION 15-03-2007 Supplementary Manual page 21

the network installation source is described in Section 4.2.1, "Setting Up an Installation
Server Using YaST" (Chapter 4, Remote Installation, ↑Installation and Administration).
2.2.4 Starting the Installation
To start the installation, reboot the system. Then enter the system firmware by pressing
F1 or 1 when using the serial console during the system check when the system is re-
booted. See Figure 2.3, "Entering the System Firmware"
Figure 2.3 Entering the System Firmware
1 = SMS Menu
8 = Open Firmware Prompt
memory
Press F1 or 1 while the SCSI devices are checked. Select 6 MultiBoot to enter the
Multiboot dialog. See
keyboard network
Figure 2.4, "Multiboot Dialog"
(page 15).
5 = Default Boot List
6 = Stored Boot List
scsi speaker
(page 16)
Preparation 15