Novell ACCESS MANAGER 3.1 SP1 - IDENTITY SERVER Manual page 22

7801 + 1 (for back-channel communication with cluster members. You need to open two
consecutive ports such as 7801 and 7802.)
636 (for secure LDAP)
389 (for clear LDAP)
524 (network control protocol on the L4 switch for server communication)
The identity provider ports must also be open:
8080 (non-secure login)
8443 (secure login)
1443 (server communication)
If you are using introductions (see
page 14), you must configure the L4 switch to load balance on ports 8445 (identity provider)
and 8446 (identity consumer).
Setup
1 Install the additional Identity Servers.
During installation, choose option 2, Install Novell Identity Server. You run the installation for
each new Identity Server you want to add. Specify the IP address and administration credentials
of each additional Identity Server. If you are installing on a machine without the Administration
Console, the installation asks you for the Administration Console's IP address. After you install
the Identity Servers, the servers are displayed on the Servers page in Identity Servers.
2 Assign the Identity Servers to the same cluster configuration (see
Identity Server to a Cluster Configuration," on page
3 Click the name of the cluster configuration.
22 Novell Access Manager 3.1 SP1 Identity Server Guide
Section 1.1.1, "Creating a Cluster Configuration," on
19).
Section 1.1.2, "Assigning an