Advertisement
Quick Links
1. Align the positioning holes on the plate bracket inside the removal plate and cabinet, put it on, and then gently
press it to tighten it.
2. Remove the drawer (see the last page for the specific disassembly and assembly method), and install the
connecting screws in the corresponding hole。
Socket Head Cap
Screw(M8*15mm)
Assembly instructions
wide margin
facing out
PT8132W260 Installation
The number of people needed for installation：
①
Please read the manual carefully before
installing this product. And strictly follow
the installation process
Please take good care of this manual
②
for your next installation
Note: Before installation, screw all the
③
screws to 1/2 of the length of the
installation. After all screws are half
screwed in, tighten them all together.
On a red ribbon are furniture
Parts list
Serial
Shape
number
Socket Head Cap
A
Screw(M8*15mm)
B
C
D
E
F
G
2
installation accessories
Quantity
Spare
Name
required for
quantity
installation
6
0
1
0
Wrench
Advertisement
Related Manuals for POVISON PT8132W260
Summary of Contents for POVISON PT8132W260
- Page 1 1. Align the positioning holes on the plate bracket inside the removal plate and cabinet, put it on, and then gently press it to tighten it. Assembly instructions wide margin facing out PT8132W260 Installation The number of people needed for installation： ① Please read the manual carefully before installing this product. And strictly follow...
- Page 2 3. For the right cabinet installation, just repeat step 2. Assembly instructions PT8132W260 Installation The number of people needed for installation： ① Please read the manual carefully before installing this product. And strictly follow the installation process Please take good care of this manual ②...
- Page 3 Disassembly and assembly instructions for two bottom buffer rail drawers 1.Two-section bottom buffer guide rail. Disassembly buckle The way to teardown drawer: Pull out the disassembly buckle of the two guide rails below the drawer at the same time. Gently pull the drawer up, and then you can take the drawer down.
- Page 4 1.Plug in the power for the cabinet. 2.Press the On-off key on the remote control to start the cabinet. (The remote control for the device is paired at the factory and can be used directly.) User guide Do not push or pull the drawers with your hands.
- Page 5 5.Use the forward and backward keys on the 6.After adjusting the position, the projector will remote control to adjust the laser projector to the automatically extend when you turn it on optimal projection distance. (After adjusting the position of the cabinet, wait for 30 seconds for the User guide position setting to be completed.
- Page 6 Battery installation instructions 2. Unscrew the set screws on the circuit board 1. Open the panel of the remote along the gap in the surface Open from here 4. Install the board in the directions shown until the board is calorie 3.
Need help?
Do you have a question about the PT8132W260 and is the answer not in the manual?
Questions and answers