NTI XTENDEX Series Installation And Operation Manual
Hdmi over gigabit ip extender
Hide thumbs
Also See for XTENDEX Series:
- User manual (42 pages) ,
- Installation and operation manual (36 pages) ,
- Manual (7 pages)
Related Manuals for NTI XTENDEX Series
Summary of Contents for NTI XTENDEX Series
- Page 1 ® XTENDEX Series ST-IPHDMI-2G HDMI Over Gigabit IP Extender Installation and Operation Manual MAN161 Rev Date 9/4/2012...
- Page 2 TRADEMARK XTENDEX is a registered trademark of Network Technologies Inc in the U.S. and other countries. COPYRIGHT Copyright © 2012 by Network Technologies Inc. All rights reserved. No part of this publication may be reproduced, stored in a retrieval system, or transmitted, in any form or by any means, electronic, mechanical, photocopying, recording, or otherwise, without the prior written consent of Network Technologies Inc, 1275 Danner Drive, Aurora, Ohio 44202.
- Page 3 NTI BRANDNAME AND DESCRIPTION INTRODUCTION The XTENDEX® HDMI Over Gigabit IP Extender multicasts digital video and audio signals to one or more receivers up to 333 feet away over a Second-Generation (2G) 1000BASE-T Gigabit Network connected with CAT5e/6/7 cable. Each HDMI Over Gigabit IP Extender consists of a local unit that connects to an HDMI source, and a remote unit that connects to an HDMI display.
- Page 4 NTI BRANDNAME AND DESCRIPTION INSTALLATION Single HDMI Source- One or More Displays For an installation involving a single HDMI source and one or more displays, the user needs only to: Connect the HDMI cables between source and Transmitter Connect the HDMI cables between display(s) and Receiver(s)
- Page 5 NTI BRANDNAME AND DESCRIPTION Video Wall Support The ST-IPHDMI-2G also supports video wall installations, with configurations from as small as 1x2 to up to 8x8 and everything in between. To configure a video wall, these steps must be followed: 1. Determine the IP address of the Transmitter.
- Page 6 NTI BRANDNAME AND DESCRIPTION 2. Connect to the Web Setup Utility NOTE: To connect to the Web Setup Utility in the transmitter your PC must be on the same subnet as the Transmitter. A. Open a browser on the PC connected to the Network Switch.
- Page 7 NTI BRANDNAME AND DESCRIPTION 4. Configure the Video Wall Under the “Basic Setup” section, fill in the blanks with applicable information. The Bezel and Gap Compensation values will setup the dimensions of the image from the transmitter that will be allocated to each display.
Need help?
Do you have a question about the XTENDEX Series and is the answer not in the manual?
Questions and answers