Table of Contents
Advertisement
Show PC Health in Post
During Enabled, it displays information list below. The choice is either Enabled or Disabled.
Smart CPUFAN/SYSFAN1/MagicDUCT Temperature/ CPUFAN, SYSFAN1,
MagicDUCT SFAN1 Speed/Vcore/ VddQ/+5V/+12V/VBAT(V)/5VSB(V)
This will show the CPU/FAN/System voltage chart and FAN Speed.
Smart CPUFAN/SYSFAN1/MagicDUCT SFAN2 Temperature
This is the special function for control the fan's speed in this motherboard.
The Settings are Disabled,
When Setting Disabled the FAN will running in full speed. If setting in 30
CPUFAN/ SYSFAN1/ MagicDUCT SFAN2 temperature is under this value the FAN will
running in 70%/80%/90% of full speed, users can setting the value depend on system
requirement. Suggest setting in Disabled let FAN running in full speed to solve the thermal
problem and cooling down the system/CPU temperature for more stable when CPU
working.
Miscellaneous Control
3-11
This section is for setting CPU Frequency/Voltage Control.
CMOS Setup Utility – Copyright(C) 1984-2004 Award Software
Auto Detect DIMM/PCI Clk
Spread Spectrum
** Current Host Clock is 133/33MHz **
Host/PCI Clock at Next Boot is
** Current DRAM Clock is 166MHz **
DRAM Clock at next Boot is
CPU Vcore Select
VDIMM Select
AGP VddQ Select
VCC2.5 Select
↑↓→← Move Enter:Select +/-/PU/PD:Value F10:Save ESC:Exit F1:General Help
F5:Previous Values
Auto Detect DIMM/PCI Clk
This item allows you to enable/disable auto detect DIMM/PCI Clock.
Spread Spectrum
This item allows you to set the CPU Host/PCI clock and Spread Spectrum.
The settings are: Enabled, Disabled.
Host Clock at next Boot is
This item allows you to select CPU frequency step by step increasing
The choice are: 100MHz∼132MHz, 133MHz∼165MHz, 166MHz∼255MHz.
DRAM Clock at next Boot is
This field displays the capability of the memory modules that you can use The choice is either
100MHz or 133MHz or 166MHz or 200MHz.
AGP VddQ Select
This item allows you to select 1.5V of the AGP 4X/8X VGA card. The choice are: 1.5V, 1.6V.
VDIMM Select
This item allows you to select 2.5V of the DDR Module. The choice are: 2.5V, 2.6V, 2.7V, 2.8V.
,
30
°C
/86
°
F, 35
°
C/95
°
F
40
Miscellaneous Control
Enabled
Disabled
133MHz/33MHz
By SPD
Default
2.5V (Default)
1.5V (Default)
2.5V (Default)
F6:Optimized Defaults
38
. Default setting is Disabled.
°
C/104
°
F
Menu Level >
F7:Standard Defaults
/35
/40
but the
°
°
°
C ,
Item Help
Advertisement
Table of Contents
