Install Memory - JETWAY V2DP - REV 1.0 User Manual

2-4 Install Memory

This motherboard provides
sites for memory expansion available from minimum memory size of 64MB to maximum
memory size of 2.0GB DDR SDRAM.
Valid Memory Configurations
Bank
Bank 0, 1 (DDR1)
Bank 2, 3 (DDR2)
Total
Generally, installing DDR SDRAM modules to your motherboard is very easy, you can refer
to figure 2-4 to see what a 184-Pin DDR200/DDR266/DDR333 DDR SDRAM module looks
like.
NOTE! When you install DIMM module fully into the DIMM socket the eject tab
should be locked into the DIMM module very firmly and fit into its
indention on both sides.
WARNING! For the DDR SDRAM CLOCK is set at 133MHz, use only DDR266-
compliant DDR Modules. When this motherboard operate at 133Mhz, most
system will not even boot if non-compliant modules are used because of the
strict timing issues, if your DDR Modules are not DDR266-compliant, set
the DDR SDRAM clock to 100MHz to ensure system stability.
two 184-pin DUAL INLINE MEMORY MODULES (DIMM)
184-Pin DIMM
DDR200/DDR266/DDR333
DDR SDRAM Module
DDR200/DDR266/DDR333
DDR SDRAM Module
System Memory (Max. 2.0GB)
PCS
X1
X1
Figure 2-4
9
Total Memory
64MB∼1.0GB
64MB∼1.0GB
2 64MB∼2.0GB